Sandbar between St. Agnes and Gugh on the Isles of Scilly off the coast of Cornwall

A shoal, sandbar (or just bar in context), sandbank or gravelbar is a somewhat linear landform within or extending into a body of water, typically composed of sand, silt or small pebbles. A spit or sandspit is a type of shoal. Shoals are characteristically long and narrow (linear) and develop where a stream or ocean current promotes deposition of granular material, resulting in localized shallowing (shoaling) of the water. Shoals can appear in the sea, in a lake, or in a river. Alternatively a bar may separate a lake from the sea, as in the case of an ayre. They are typically composed of sand, although could be of any granular matter that the moving water has access to and is capable of shifting around (for example, soil, silt, gravel, cobble, shingle, or even boulders). The grain size of the material comprising a bar is related to the size of the waves or the strength of the currents moving the material, but the availability of material to be worked by waves and currents is also important.

The term bar can apply to landform features spanning a considerable range in size, from a length of a few metres in a small stream to marine depositions stretching for hundreds of kilometres along a coastline, often called barrier islands.

In a nautical sense, a bar is a shoal, similar to a reef: a shallow formation of (usually) sand that is a navigation or grounding hazard, with a depth of water of six fathoms 6 fathoms (11 metres) or less. It therefore applies to a silt accumulation that shallows the entrance to the course of a river or creek.

Shoaling[link]

When surface waves move towards shallow water, such as a beach, they slow down, their wave height increases and the distance between waves decreases. This behaviour is called shoaling, and the waves are said to shoal. The waves may or may not build to the point where they break, depending on how large they were to begin with, and how steep the slope of the beach is. In particular, waves shoal as they pass over submerged sandbanks or reefs. This can be treacherous for boats and ships. It's good for surfers.

Shoaling can also diffract waves, so the waves change direction. For example, if waves pass over a sloping sandbank which is shallower at one end than the other, then the shoaling effect will result in the waves slowing more at the shallow end. Thus the wave fronts will refract, changing direction like light passing through a prism. Refraction also occurs as waves move towards a beach if the waves come in at an angle to the beach, or if the beach slopes more gradually at one end than the other.

Sandbars and longshore bars[link]

A sandbar off Suffolk County, Long Island, New York, August 2006.

This bar forms (sometimes seaward of a trough) where the waves are breaking, because the breaking waves set up a shoreward current with a compensating counter-current along the bottom. Also known as a trough bar. Sand carried by the offshore moving bottom current is deposited where the current reaches the wave break.^[1] Other longshore bars may lie further offshore, representing the break point of even larger waves, or the break point at low tide.

Harbour and river bars[link]

The Doom Bar sand bank extends across the River Camel estuary in Cornwall, UK

A harbour or river bar is a sedimentary deposit formed at a harbour entrance or river mouth by the deposition of sediment or the action of waves on the sea floor or adjacent beaches. A bar can form a dangerous obstacle to shipping, preventing access to the river or harbour in unfavourable weather conditions or at some states of the tide. Where beaches are suitably mobile, or the river’s suspended and/or bed loads are large enough, wave action can build up a bar to completely block a river mouth, damming the river, preventing access for boats or shipping, and causing flooding in the lower reaches of the river. This situation will persist until the bar is eroded by the sea, or the dammed river develops sufficient head to break through the bar.

Shoals as geological units[link]

Shoals in the Mississippi River at Arkansas and Mississippi.

A tidal sandbar connecting the islands of Waya and Wayasewa of the Yasawa Islands, Fiji

In addition to longshore bars discussed above that are relatively small features of a beach, the term shoal can be applied to larger geological units that form off a coastline as part of the process of coastal erosion. These include spits and baymouth bars that form across the front of embayments and rias. A tombolo is a bar that forms an isthmus between an island or offshore rock and a mainland shore.

The largest of the geological units of this kind is a barrier island, such as occur along the East Coast of the United States, along the Gulf coast, along the southern coast of Belize and many other locations worldwide.

In places of re-entrance along a coastline (such as inlets, coves, rias, and bays), sediments carried by a longshore current will fall out where the current dissipates, forming a spit. An area of water isolated behind a large bar is called a lagoon. Over time, lagoons may silt up, becoming salt marshes.

In some cases shoals may be precursors to beach expansion and dunes formation, providing a source of windblown sediment to augment such beach or dunes landforms.^[2]

Specific geology[link]

This unreferenced section requires citations to ensure verifiability.

The barrier island can be separated into sections for easy study.

Lower shoreface[link]

The shoreface is the part of the barrier where the ocean meets the shore of the island. The barrier island body itself separates the shoreface from the backshore and lagoon/tidal flat area. Characteristics common to the lower shoreface are fine sands with mud and possibly silt. Further out into the ocean the sediment becomes finer. The effect from the waves at this point is weak because of the depth. Bioturbation is common and many fossils can be found here.

Middle shoreface[link]

The middle shore face is located in the upper shoreface. The middle shoreface is strongly influenced by wave action because of its depth. Closer to shore the grain size will be medium size sands with shell pieces common. Since wave action is heavier, bioturbation is not likely.

Upper shoreface[link]

The upper shoreface is constantly effected by wave action. This results in development of herringbone sedimentary structures because of the constant differing flow of waves. Grain size is larger sands.

Foreshore[link]

The foreshore is the area on land between high and low tide. Like the upper shoreface, it is constantly affected by wave action. Cross bedding and lamination are present and coarser sands are present because of the high energy present by the crashing of the waves. The sand is also very well sorted.

Backshore[link]

The backshore is always above the highest water level point. The berm is also found here which marks the boundary between the foreshore and backshore. Wind is the important factor here, not water. During strong storms high waves and wind can deliver and erode sediment from the backshore.

Dunes[link]

The dunes are located at the top of the backshore. The dunes are typical of a barrier island. The high sand dunes are only affected by wind because of their height. Similarly, strong storms are the only thing that really affect the size of the dunes. The dunes will display characteristics of typical eolian wind blown dunes. The difference here is that dunes on a barrier island typically contain vegetation roots and marine bioturbation. .

Lagoon and tidal flats[link]

The lagoon and tidal flat area is located behind the dune and backshore area. Here the water is still and this allows for fine silts, sands, and mud to settle out. Lagoons can become host to an anaerobic environment. This will allow high amounts of organic rich mud to form. Vegetation is also common.

Human habitation[link]

Since prehistoric times humans have chosen some shoals as a site of habitation. In some early cases the locations provided easy access to exploit marine resources.^[3] In modern times these sites are sometimes chosen for the water amenity or view, but many such locations are prone to storm damage.^[4][5]

See also[link]

Wikimedia Commons has media related to: Shoals

• Adam's Bridge
• Bank (geography)
• Barrier island
• Ocean bank (topography)
• Shingle beach
• Tidal island
• U.S. Coastal Barrier Resources Act of 1982

Notes[link]

v t e Coastal geography Landforms Anchialine pool Avulsion Archipelago Atoll Ayre Barrier bar Barrier island Bay Baymouth bar Bight Brackish marsh Cape Channel Cliff Cliffed coast Cliff-top dune Coast Coastal plain Coastal waterfall Continental margin Continental shelf Coral reef Cove Dune Estuary Firth Fjard Fjord Flat coast Freshwater marsh Fundus Gat Geo Graded shoreline Gulf Headland Inlet Intertidal wetland Island Islet Isthmus Lagoon Marine terrace Mouth bar Raised shorelines Machair Mega delta Mudflat Natural arch Peninsula Reef Regressive delta Ria River delta Rocky shore Salt marsh Shore Sound Stack Steep coast Strait Strand plain Submarine canyon Tied island Tidal island Tidal marsh Tide pool Tombolo More... Beaches Beach cusps Beach evolution Beach ridge Beachrock Modern recession of beaches Pocket beach Raised beach Storm beach Shingle beach Processes Blowhole Coastal erosion Concordant coastline Current Cuspate foreland Discordant coastline Emergent coastline Feeder bluff Fetch Headlands and bays Large scale coastal behaviour Longshore drift Marine regression Marine transgression Rip current Sea cave Sea foam Shoal Spit Submergent coastline Surf break Surf zone Surge channel Swash Volcanic arc Wave-cut platform Wave shoaling Wind wave Wrack zone Management Coastal management Accretion Integrated coastal zone management Submersion Related Bulkhead line Coastline length Intertidal zone Littoral zone Particle size boulder shingle pebble sand silt clay Physical oceanography Region of freshwater influence Scree More...