Ski Jumping Equipment
Bindings
The binding must be mounted parallel to the run-direction. The binding must be placed in such a way that a maximum 57% of the entire ski length is used as the front part.
Boots
High-backed, flexible yet firm boots with a low cut at the front. They are designed to allow the skier to lean forward during flight.
Connection cord
Part of the binding; a cord that attaches the ski to the boot and prevents the wobbling of skis during flight.
Ski jumping suit
All portions of the ski jumping suit must be made of the same material and must show a certain air permeability. The size of the suit must conform to the body shape in an upright position with certain tolerances.
Jumping skis
Jumping skis are manufactured especially for use on ski jumping hills. Skis with a length of a maximum 146% of the total body height of the competitor may be used. The curvature and shape of the skis is restricted by certain geometric features.
Cross-country skiing equipment
Bindings
Bindings secure only the toe of the boot to the ski.
Boots
The skating shoe is fixed to the ski with a binding, holding the toe firm. The rear of the boot is built up to shore up the ankle, which is constantly under pressure in skating technique.
Poles
Long and straight, often reaching up as high as a competitor's chin, with a specially shaped basket designed to allow skiers to push hard and evacuate snow.
Skis
Narrower and lighter than those used in Alpine skiing. They have long, curved ends and rise up slightly in the middle. They can be up to 2 meters long.
Suit
Uses stretch fabric hugging the body, similar to a runner’s training clothing.
Wax
Glide wax is crucial, and determined by snow and weather conditions.