PICT

PICT is a graphics file format introduced on the original Apple Macintosh computer as its standard metafile format. It allows the interchange of graphics (both bitmapped and vector), and some limited text support, between Mac applications, and was the native graphics format of QuickDraw.

The PICT file format consists essentially of serialized QuickDraw opcodes. The original version, PICT 1, was designed to be as compact as possible while describing vector graphics. To this end, it featured single byte opcodes, many of which embodied operations such as "do the previous operation again". As such it was quite memory efficient, but not very expandable. With the introduction of the Macintosh II and Color QuickDraw, PICT was revised to version 2. This version featured 16-bit opcodes and numerous changes which enhanced its utility. PICT 1 opcodes were supported as a subset for backward compatibility.

Within a Mac application, any sequence of drawing operations could be simply recorded/encoded to the PICT format by opening a "Picture", then closing it after issuing the required commands. By saving the resulting byte stream as a resource, a PICT resource resulted, which could be loaded and played back at any time. The same stream could be saved to a data file on disk (with 512 bytes of unused header space added) as a PICT file.

PCT

PCT, P.C.T. or pct may refer to:

Geography

History

Law

Medicine

Science and technology

Hot shoe

A hot shoe is a mounting point on the top of a camera to attach a flash unit and other compatible accessories.

Design

The hot shoe is shaped somewhat like an inverted, squared-off "U" of metal. The matching adapter on the bottom of the flash unit slides in from the back of the camera and is sometimes secured by a clamping screw on the flash. In the center of the "U" is a metal contact point. This is used for standard, brand-independent flash synchronization. Normally the metal of the shoe and the metal of the contact are electrically isolated from each other. To fire the flash, these two pieces are shorted together. The flash unit sets up a circuit between shoe and contact—when it is completed by the camera, the flash fires.

In addition to the central contact point, many cameras have additional metal contacts within the "U" of the hot shoe. These are proprietary connectors that allow for more communication between the camera and a "dedicated flash". A dedicated flash can communicate information about its power rating to the camera, set camera settings automatically, transmit color temperature data about the emitted light, and can be commanded to light a focus-assist light or fire a lower-powered pre-flash for focus-assist, metering assist or red-eye effect reduction.