Tani and Matthew performing part of the process to extract Ormus from Dead Sea salt , at the Pulphouse , in Arizona ........ Featured in this video is the Egyptian Wet Method process and it is a solid reliable process ..... We have performed The Egyptian Method many times here with consistent results ........ We were unable to edit video at the time so we didn't show the process of making the natron solution (which takes place before what you see in the video) , and the washing process (which takes place after what you see in the video) ... Bromine, Sodium and Potassium are all removed from the precipitate by the washing process, and it is performed as follows: after settling: wash it thoroughly at least three times by decanting,mixing with pure water, letting it settle and decanting again , rinse and repeat , quite literally! (hehe) ..... There are no Gilcrest elements in Dead Sea Salt so overshooting a PH of 10.78 by a bit is really nothing to be concerned about, therefore no need to use a PH meter if you use these measurements (as used in the video).................. So ok, for the sake of detail and clarity --- STARTING FROM THE BEGINNING: First make your sodium carbonate solution by thoroughly baking 1 pound of Sodium Bicarbonate (Baking soda) in your oven on high for at least a few hours which turns the powder into Sodium carbonate (aka "Natron" or "Washing Soda") and then dissolve that natron powder into 36 ounces of water , and VOILA this is your concentrated sodium solution which will act as your alkaline reagent........It only requires about 140 milliliters of this alkaline sodium solution per batch so 36 ounces should be enough for several of these small batches..... Add your 140 milliliters of sodium (natron) solution to 24 ounces of water and set it aside for later... ...... Next make your reconstituted Dead Sea water by dissolving 2 to 3 tablespoons (yes this recipe is just THAT forgiving! =) ) into 24 ounces of water (reverse osmosis, distilled , or spring water etc) and the video demonstrates how to mix your two solutions and what to expect.....Set this milky looking solution (Hathor's milk) into a dark space (like a closet) with no strong magnetic fields nearby ...You can wrap the container with aluminum foil for further protection from RF or other high frequency EM fields while the precip is settling, but honestly Ormus is very stable with this much sodium present, but that will change after the washing is finished...... Potency degrades quickly after the washings, so you want to use it over the next few days after the final wash ........ This decanting/washing process can begin after the precip is fully settled which may take a few days , but it will settle faster after the first wash .............. Perhaps i will post an edited video showing all of the steps in more detail in the near future ...... NOTE: You can dissolve the finished precip in fresh Lemon juice, I highly recommend mixing this with something that contains live beneficial bacteria (like a good Yogurt , Kefir , Kombucha, Kevita, or EM1 if you are feeding plants), this will enhance the effects of the Ormus.

• published: 18 Apr 2014
• views: 11381