Update 1/31/2014: Use Discount Coupon Code YT5 to get $5 off your next online order at www.SADOUN.com . (Limited time offer). Instructions on how to install and align a motorized satellite dish. Go to http://www.sadoun.com/Sat/Installation/Installation.htm Steps to a successful motorized system installation: ~ Select your installation site carefully!!! ~ There must be a clear line of sight between the required satellites and the entire surface of the dish. The line of sight must be free from obstructions, such as trees, roof tiles etc. ~ It is very important to make sure the HH motor is fixed to a perfectly vertical (plumb) mast. Time spent measuring this accurately will save you hours later on. ~ NOTE: Tighten all coaxial cable connections on the motor only by hand. Using a wrench may over-tighten the connections, causing damage. Such damage is not covered by the Limited warranty. ~ If the HH motor shaft is not at zero degrees reference, you should get it back to zero degrees by connecting the receiver to the motor. The receiver must be ON for the HH Motor to move. Its easier to do this before placing the H-H Motor onto the mast. Once you have done this, the HH Motor should then be disconnected from the receiver. HH Motors are usually set to zero degrees by default from the factory. ~ Fit the H-H Motor onto the mast and do the nuts up finger tight, ~ Set the elevation angle for the motor. This angle should be equal to the latitude value of the installation location. Always use the Latitude scale on the motor. ~ Fit the dish on the H-H Motor shaft and tighten the nuts. The middle of the dish clamp must be lined up with the center line on the H-H Motor arm. The LNBF arm, dish clamp, HH Motor, and mast must all be on the same straight line facing TRUE SOUTH. ~ Aiming at TRUE SOUTH: Find your TRUE SOUTH Angle here. Then using a compass, move the dish/motor assembly together as one unit to your TRUE SOUTH angle. ~ Dish elevation angle: Adjust the dish elevation angle to peak the signal. Dish elevation angle is calculated based on the model of the HH motor you are using, as follows: .....rest of the instructions here: http://www.sadoun.com/Sat/Installation/HH-mount-installation.htm Please embed this video on your website or forum. Also, add to your Facebook profile. Please embed this video on your website or forum. Also, add to your Facebook profile. Please embed this video on your website or forum. Also, add to your Facebook profile. More information: http://www.Sadoun.com Follow me on: Google+: https://plus.google.com/u/0/+sadoun Twitter: https://twitter.com/sadoun Facebook: https://www.facebook.com/sadoun Flickr: http://www.flickr.com/photos/sadoun/ Pnterest: http://www.pinterest.com/sadoun/ Share Video: Subscribe to my channel: http://www.youtube.com/user/SadounTube?sub_confirmation=1

• published: 28 Aug 2008
• views: 530431