Rotary Kiln general overview | Part description & functioning | Incinerator | Pyroprocessing Please LIKE | SUBSCRIBE | SHARE our you tube video for our motivation & please do not forget to hit the bell icon button for latest update. Mr. JK Singh (Whattapp +91-8106351454) has rich experience in cement plant project designing, operation & maintenance of equipment, etc. Email-ID for any Technical Guidance & support : cementpdm@gmail.com Please give your valuable comments & suggestion in comment box for continuous improvement. The kiln is a cylindrical vessel, inclined slightly to the horizontal, which is rotated slowly about its longitudinal axis. The process feedstock is fed into the upper end of the cylinder. As the kiln rotates, material gradually moves down toward the lower end, and may undergo a certain amount of stirring and mixing. Hot gases pass along the kiln, sometimes in the same direction as the process material (co-current), but usually in the opposite direction (counter-current). The hot gases may be generated in an external furnace, or may be generated by a flame inside the kiln. Such a flame is projected from a burner-pipe (or "firing pipe") which acts like a large bunsen burner. The fuel for this may be gas, oil, pulverized petroleum coke or pulverized coal. Kiln shell: This is made from rolled mild steel plate, usually between 30 to 100 mm thick, welded to form a cylinder which may be up to 120 m in length and up to 6 mtr in diameter. Refractory lining: The purpose of the refractory lining is to insulate the steel shell from the high temperatures inside the kiln, and to protect it from the corrosive properties of the process material. It may consist of refractory bricks or cast refractory concrete, or may be absent in zones of the kiln that are below approximately 250 °C. Tyres and rollers: Tyres, sometimes called riding rings, usually consist of a single annular steel casting, machined to a smooth cylindrical surface, which attach loosely to the kiln shell through a variety of "chair" arrangements. These require some ingenuity of design, since the tyre must fit the shell snugly, but also allow thermal movement. The tyre rides on pairs of steel rollers, also machined to a smooth cylindrical surface, and set about half a kiln-diameter apart. Drive Girth gear & Pinion: The kiln is usually turned by means of a single Girth Gear surrounding a cooler part of the kiln tube, but sometimes it is turned by driven rollers. The gear is connected through a gear train to a variable-speed electric motor. This must have high starting torque to start the kiln with a large eccentric load. A 6 x 60 m kiln requires around 800 kW to turn at 3 rpm. The speed of material flow through the kiln is proportional to rotation speed, and so a variable speed drive is needed to control this. #Rotarykiln #Pyroprocessing #Kiln #Cementmanufacturingprocess #Cementplant #Preheater #Rawmill #Cementmill #Incinerator

• published: 08 Apr 2020
• views: 101726