Duron

AMD Duron "Spitfire" 600MHz CPU
Produced	From mid 2000 to 2006
Common manufacturer(s)	AMD
Max. CPU clock rate	600 MHz to 1.8 GHz
FSB speeds	200 MT/s to 266 MT/s
Min. feature size	0.18 to 0.13
Instruction set	x86
Socket(s)	Socket A
Core name(s)	Spitfire Morgan Applebred

The AMD Duron was an x86-compatible microprocessor manufactured by AMD. It was released on June 19, 2000 as a low-cost alternative to AMD's own Athlon processor and the Pentium III and Celeron processor lines from rival Intel. The Duron was discontinued in 2004 and succeeded by the Sempron.

Development[link]

The Duron was pin-compatible with the Athlon and carried all of the computational resources from it, operating on the same motherboards in most cases. The original Duron was limited to operating on a 100 MHz front-side bus speed (FSB 200), while the Athlon at the time could run on a bus clock of 133 MHz (FSB 266). Later Durons supported a 133 MHz bus (FSB 266) while Athlon XP ran at 166/200 MHz FSB (FSB 333/400). The original Duron, using the "Spitfire" core, was manufactured in 2000 and 2001 at speeds ranging from 600 to 950 MHz. It was based on the 180 nm "Thunderbird" Athlon core. The second-generation Duron, the "Morgan" core, was sold in speed grades between 900 and 1300 MHz, and was based on the 180 nm "Palomino" Athlon XP core. As a result, it featured a few important enhancements namely full Intel SSE support, enlarged TLBs, hardware data prefetch, and an integrated thermal diode. Like the "Palomino" core, "Morgan" was also expected to reduce the core heat dissipation, however in "Morgan"'s case this did not happen due to its increased core voltage. The final generation Duron was called "Applebred", sometimes called "Appalbred", and was based on the "Appaloosa" Duron along with the 130 nm "Thoroughbred" Athlon XP. "Appaloosa" was never officially announced but it did see very limited circulation.

Duron's biggest difference from Athlon was its reduction in cache size to 64 KB, in contrast to the 256 KB or even 512 KB of Athlon. This was a relatively tiny amount of L2 cache, even smaller than the 128 KB L2 on Intel's Celeron. However, the K7-architecture enjoyed one of the largest L1 caches, at 128 KB (split 64+64 KB). And, with the arrival of the socketed Athlon/Duron chips, AMD switched to an exclusive cache design which did not mirror data between the L1 and L2 like the inclusive cache used on the Slot A K7, a critical feature in a low-cache situation. An exclusive design greatly favors L1 cache as the primary caching resource, while the slower L2 cache stores victim or copy-back cache blocks to be written back to main memory (LRU). The L2 cache essentially acts as an overflow from the L1 cache. Because of the lack of duplication between caches, Duron can be said to have 192 KB cache onboard, whereas an inclusive chip such as Athlon Slot-A, with 512 KB L2, would only have, in practice, 512 KB total (640K-128K). Celeron was in the same boat with its inclusive cache for a total of 128 KB (160K-32K).

Consequently, the post-Slot-A K7-architecture was less sensitive to L2 cache size. This reduced reliance upon L2 cache also allowed AMD to make their L2 cache higher latency and lower bandwidth without significant performance loss, which lessened processor complexity and allowed better manufacturing yields. AMD's Duron "Spitfire" CPU was only roughly 10% slower than its big brother, Athlon "Thunderbird".

Duron was often a favorite of computer builders looking for performance while on a tight budget. Perhaps most notably, in 2003 the "Applebred" Duron was available in 1.4 GHz, 1.6 GHz and 1.8 GHz forms, all on a 133 MHz (FSB 266) bus by default. Enthusiast groups quickly discovered these Durons to be rebadged Thoroughbred A/B cores with some cache disabled (and perhaps defective). With a basic chip configuration modification, it was found that "Applebred" could be turned into "Thoroughbred B" Athlon XPs, with full 256KB cache, with a very high success rate. However, this was only possible for a period of approximately 4 weeks, as shortly after the Applebred was released, AMD changed the chip configuration method to one that was not changeable.

Duron core data[link]

Spitfire (Model 3, 180 nm)[link]

"Spitfire" Duron, 600MHz.

• L1-Cache: 64 + 64 KB (Data + Instructions)
• L2-Cache: 64 KB, fullspeed
• MMX, Extended MMX, 3DNow!, Extended 3DNow!
• Socket A (EV6)
• Front side bus: 100 MHz (200 MT/s)
• VCore: 1.50 V - 1.60 V
• First release: June 19, 2000
• Clockrate: 600 MHz - 950 MHz

Morgan (Model 7, 180 nm)[link]

"Morgan" Duron, 1.3GHz.

• L1-Cache: 64 + 64 KB (Data + Instructions)
• L2-Cache: 64 KB, fullspeed
• MMX, Extended MMX, 3DNow!, Extended 3DNow!, SSE
• Socket A (EV6)
• Front side bus: 100 MHz (200 MT/s)
• VCore: 1.75 V
• First release: August 20, 2001
• Clockrate: 900 MHz - 1300 MHz

Applebred (Model 8, 130 nm)[link]

"Applebred" Duron, "A"-model, 1.6GHz.

• L1-Cache: 64 + 64 KB (Data + Instructions)
• L2-Cache: 64 KB, fullspeed
• MMX, Extended MMX, 3DNow!, Extended 3DNow!, SSE
• Socket A (EV6)
• Front side bus: 133 MHz (266 MT/s)
• VCore: 1.50 V
• First release: August 21, 2003
• Clockrate: 1400, 1600, 1800 MHz

See also[link]

List of AMD Duron microprocessors

References[link]

• "AMD Duron (64 KB integrated Level 2 cache)" by Anthony Barrett, Processor Emporium, retrieved January 13, 2006
• "cpu-museum.de New additions to the museum (Appalbred)", by Christian "Grampa", January 7, 2004, retrieved January 9, 2006
• "IA-32 implementation AMD K7 (inclusive on Slot A)" by Sandpile.org, retrieved January 9, 2006
• "Press Release: AMD Athlon Processor Performance-Enhancing Cache Memory" by AMD, June 4, 2000, retrieved January 13, 2006

External links[link]

• Budget CPU Shootout - Popular hardware review website Anandtech compares low priced CPUs
• cpu-collection.de AMD Duron processor images and descriptions

Corey Allen Brown (born November 26, 1985 in Tampa, Florida, USA) is a Major League Baseball center fielder for the Washington Nationals. He is 6'1" tall and he weighs 205 pounds.

Prior to playing professionally, Brown attended Plant High School and then Oklahoma State University. In his first year with Oklahoma State, in 2005, Brown hit .360 with 13 home runs and 46 RBI in 55 games. The following year, he hit .347 with 13 home runs and 40 RBI, stealing 14 bases. 2007 was his final year with Oklahoma State, and he hit .335 with 22 home runs, 71 RBI and 23 stolen bases that season. He was drafted by the Oakland Athletics in the first round of the 2007 amateur draft and began his professional career that season.

Brown played for the Vancouver Canadians in 2007, hitting .268 with 11 home runs and 48 RBI in 59 games. In 2008, he played for both the Kane County Cougars (85 games, 14 home runs) and the Stockton Ports (49 games, 16 home runs), hitting a combined .266 with 30 home runs, 83 RBI and 16 stolen bases. In 2009, Brown spent his entire year with the Midland RockHounds, hitting .268 with nine home runs and 43 RBI. He split 2010 between the RockHounds and Sacramento River Cats, hitting a combined .283 with 15 home runs, 69 RBI and 22 stolen bases.

On December 16, 2010 Brown along with pitcher Henry Rodriguez were traded to the Washington Nationals for Josh Willingham.^[1]

He made his major league debut for the Washington Nationals on September 6, 2011, but only appeared in 3 games in the 2011 season, pinch-hitting all three times, and never got on base.^[2]

References[link]

External links[link]

• Career statistics and player information from Baseball-Reference, or Baseball-Reference (Minors)