The second (SI symbol: s), sometimes abbreviated sec., is a unit of measurement of time, and is the International System of Units (SI) base unit of time. It may be measured using a clock.

Early definitions of the second were based on the apparent motion of the sun around the earth. The solar day was divided into 24 hours, each of which contained 60 minutes of 60 seconds each, so the second was of the mean solar day. However, 19th- and 20th century astronomical observations revealed that this average time is lengthening, and thus the sun/earth motion is no longer considered a suitable basis for definition. With the advent of atomic clocks, it became feasible to define the second based on fundamental properties of nature. Since 1967, the second has been defined to be periods of the radiation corresponding to the transition between the two hyperfine levels of the ground state of the caesium 133 atom.}}

SI prefixes are frequently combined with the word second to denote subdivisions of the second, e.g., the millisecond (one thousandth of a second), the microsecond (one millionth of a second), and the nanosecond (one billionth of a second). Though SI prefixes may also be used to form multiples of the second such as kilosecond (one thousand seconds), such units are rarely used in practice. The more common larger non-SI units of time are not formed by powers of ten; instead, the second is multiplied by 60 to form a minute, which is multiplied by 60 to form an hour, which is multiplied by 24 to form a day.

The second is also the base unit of time in the centimetre-gram-second, metre-kilogram-second, metre-tonne-second, and foot-pound-second systems of units.

International second

Under the International System of Units (via the International Committee for Weights and Measures, or CIPM), since 1967 the second has been defined as the duration of periods of the radiation corresponding to the transition between the two hyperfine levels of the ground state of the caesium 133 atom. In 1997 CIPM added that the periods would be defined for a caesium atom at rest, and approaching the theoretical temperature of absolute zero, and in 1999, it included corrections from ambient radiation.

This definition refers to a caesium atom at rest at a temperature of 0 K (absolute zero). Absolute zero implies no movement, and therefore zero external radiation effects (i.e., zero local electric and magnetic fields). The second thus defined is consistent with the ephemeris second, which was based on astronomical measurements. (See History below.)

The realization of the standard second is described briefly in a special publication from the National Institute of Science and Technology, and in detail by the National Research Council of Canada.

Equivalence to other units of time

1 international second is equal to:

1/60 minute (but see also leap second)

1/3,600 hour

1/86,400 day (IAU system of units)

1/31,557,600 Julian year (IAU system of units)

History

Before mechanical clocks

The Egyptians subdivided daytime and nighttime into twelve hours each since at least 2000 BC, hence the seasonal variation of their hours. The Hellenistic astronomers Hipparchus (c. 150 BC) and Ptolemy (c. AD 150) subdivided the day sexagesimally and also used a mean hour day)}}, simple fractions of an hour (, , etc.) and time-degrees ( day or four modern minutes), but not modern minutes or }}

The day was subdivided sexagesimally, that is by , by of that, by of that, etc., to at least six places after the sexagesimal point (a precision of less than 2 microseconds) by the Babylonians after 300 BC, but they did not sexagesimally subdivide smaller units of time. For example, six fractional sexagesimal places of a day was used in their specification of the length of the year, although they were unable to measure such a small fraction of a day in real time. As another example, they specified that the mean synodic month was 29;31,50,8,20 days (four fractional sexagesimal positions), which was repeated by Hipparchus and Ptolemy sexagesimally, and is currently the mean synodic month of the Hebrew calendar, though restated as 29 days 12 hours 793 halakim (where 1 hour = 1080 halakim). The Babylonians did not use the hour, but did use a double-hour lasting 120 modern minutes, a time-degree lasting four modern minutes, and a barleycorn lasting 3 modern seconds (the helek of the modern Hebrew calendar).

In 1000, the Persian scholar al-Biruni gave the times of the new moons of specific weeks as a number of days, hours, minutes, seconds, thirds, and fourths after noon Sunday. In 1267, the medieval scientist Roger Bacon stated the times of full moons as a number of hours, minutes, seconds, thirds, and fourths (horae, minuta, secunda, tertia, and quarta) after noon on specified calendar dates. Although a third for of a second remains in some languages, for example Polish (tercja) and Turkish (salise), the modern second is subdivided decimally.

Seconds measured by mechanical clocks

The earliest clocks to display seconds appeared during the last half of the 16th century. The earliest spring-driven timepiece with a second hand which marked seconds is an unsigned clock depicting Orpheus in the Fremersdorf collection, dated between 1560 and }} During the 3rd quarter of the 16th century, Taqi al-Din built a clock with marks every 1/5 minute. In 1579, Jost Bürgi built a clock for William of Hesse that marked }} In 1581, Tycho Brahe redesigned clocks that displayed minutes at his observatory so they also displayed seconds. In 1587 he complained that his four clocks disagreed by plus or minus four }}

The second first became accurately measurable with the development of pendulum clocks keeping mean time (as opposed to the apparent time displayed by sundials), specifically in 1670 when William Clement added a seconds pendulum to the original pendulum clock of Christian Huygens. The seconds pendulum has a period of two seconds, one second for a swing forward and one second for a swing back, enabling the longcase clock incorporating it to tick seconds. From this time, a second hand that rotated once per minute in a small subdial began to be added to the clock faces of precision clocks.

Modern measurements

In 1956 the second was defined in terms of the period of revolution of the Earth around the Sun for a particular epoch, because by then it had become recognized that the Earth's rotation on its own axis was not sufficiently uniform as a standard of time. The Earth's motion was described in Newcomb's Tables of the Sun (1895), which provide a formula estimating the motion of the Sun relative to the epoch 1900 based on astronomical observations made between 1750 and 1892. The second thus defined is

This definition was ratified by the Eleventh General Conference on Weights and Measures in 1960. The tropical year in the definition was not measured, but calculated from a formula describing a mean tropical year that decreased linearly over time, hence the curious reference to a specific instantaneous tropical year. This definition of the second was in conformity with the ephemeris time scale adopted by the IAU in 1952, defined as the measure of time that brings the observed positions of the celestial bodies into accord with the Newtonian dynamical theories of their motion (those accepted for use during most of the 20th century being Newcomb's Tables of the Sun, used from 1900 through 1983, and Brown's Tables of the Moon, used from 1923 through 1983).

With the development of the atomic clock, it was decided to use atomic clocks as the basis of the definition of the second, rather than the revolution of the Earth around the Sun.

Following several years of work, Louis Essen from the National Physical Laboratory (Teddington, England) and William Markowitz from the United States Naval Observatory (USNO) determined the relationship between the hyperfine transition frequency of the caesium atom and the ephemeris second. Using a common-view measurement method based on the received signals from radio station WWV, they determined the orbital motion of the Moon about the Earth, from which the apparent motion of the Sun could be inferred, in terms of time as measured by an atomic clock. They found that the second of ephemeris time (ET) had the duration of 9,192,631,770 ± 20 cycles of the chosen caesium frequency. As a result, in 1967 the Thirteenth General Conference on Weights and Measures defined the second of atomic time in the International System of Units as

This SI second, referred to atomic time, was later verified to be in agreement, within 1 part in 10¹⁰, with the second of ephemeris time as determined from lunar observations. (Nevertheless, this SI second was already, when adopted, a little shorter than the then-current value of the second of mean solar time.)

During the 1970s it was realized that gravitational time dilation caused the second produced by each atomic clock to differ depending on its altitude. A uniform second was produced by correcting the output of each atomic clock to mean sea level (the rotating geoid), lengthening the second by about 1. This correction was applied at the beginning of 1977 and formalized in 1980. In relativistic terms, the SI second is defined as the proper time on the rotating geoid.

The definition of the second was later refined at the 1997 meeting of the BIPM to include the statement

The revised definition seems to imply that the ideal atomic clock contains a single caesium atom at rest emitting a single frequency. In practice, however, the definition means that high-precision realizations of the second should compensate for the effects of the ambient temperature (black-body radiation) within which atomic clocks operate, and extrapolate accordingly to the value of the second at a temperature of absolute zero.

Today, the atomic clock operating in the microwave region is challenged by atomic clocks operating in the optical region. To quote Ludlow et al., “In recent years, optical atomic clocks have become increasingly competitive in performance with their microwave counterparts. The overall accuracy of single trapped ion based optical standards closely approaches that of the state-of-the-art caesium fountain standards. Large ensembles of ultracold alkaline earth atoms have provided impressive clock stability for short averaging times, surpassing that of single-ion based systems. So far, interrogation of neutral atom based optical standards has been carried out primarily in free space, unavoidably including atomic motional effects that typically limit the overall system accuracy. An alternative approach is to explore the ultranarrow optical transitions of atoms held in an optical lattice. The atoms are tightly localized so that Doppler and photon-recoil related effects on the transition frequency are eliminated.”

The NRC attaches a "relative uncertainty" of 2.5 (limited by day-to-day and device-to-device reproducibility) to their atomic clock based upon the ¹²⁷I₂ molecule, and is advocating use of an ⁸⁸Sr ion trap instead (relative uncertainty due to linewidth of 2.2). See magneto-optical trap and Such uncertainties rival that of the NIST F-1 caesium atomic clock in the microwave region, estimated as a few parts in 10¹⁶ averaged over a day.

SI multiples

SI prefixes are commonly used to measure time less than a second, but rarely for multiples of a second. Instead, the non-SI units minutes, hours, days, Julian years, Julian centuries, and Julian millennia are used.

Other current definitions

For specialized purposes, a second may be used as a unit of time in time scales where the precise length differs slightly from the SI definition. One such time scale is UT1, a form of universal time. McCarthy and Seidelmann refrain from stating that the SI second is the legal standard for timekeeping throughout the world, saying only that "over the years UTC [which ticks SI seconds] has become either the basis for legal time of many countries, or accepted as the de facto basis for standard civil time".

See also

Atomic clock

Becquerel

Coordinated Universal Time

Hertz

International Atomic Time

International System of Units

Leap second

Magneto-optical trap

Time standard

References

External links

National Physical Laboratory: Trapped ion optical frequency standards

High-accuracy strontium ion optical clock; National Physical Laboratory (2005)

National Research Council of Canada: Optical frequency standard based on a single trapped ion

NIST: Definition of the second; notice the cesium atom must be in its ground state at 0 K

Official BIPM definition of the second

Seconds and leap seconds by the USNO

The leap second: its history and possible future

What is a Cesium atom clock?

Category:Centimetre gram second system of units Category:Orders of magnitude (time) Category:SI base units Category:Units of time

als:Sekunde am:ሴኮንድ ar:ثانية an:Segundo arc:ܪܦܦܐ ast:Segundu az:Saniyə bn:সেকেন্ড ba:Секунд be:Секунда be-x-old:Сэкунда (адзінка вымярэньня часу) bo:སྐར་ཆ། bs:Sekunda br:Eilenn (amzer) bg:Секунда ca:Segon cs:Sekunda cy:Eiliad da:Sekund de:Sekunde et:Sekund el:Δευτερόλεπτο es:Segundo eo:Sekundo eu:Segundo fa:ثانیه hif:Second fr:Seconde (temps) fy:Sekonde ga:Soicind gl:Segundo gan:秒 gu:સેકન્ડ hak:Miéu ko:초 (시간) hi:सेकण्ड hr:Sekunda io:Sekundo id:Detik ia:Secunda is:Sekúnda it:Secondo he:שנייה krc:Секунд ka:წამი kk:Секунд sw:Sekunde ht:Segonn la:Secundum lv:Sekunde lb:Sekonn lt:Sekundė li:Secónd jbo:snidu hu:Másodperc mk:Секунда mg:Segondra ml:സെക്കന്റ് mr:सेकंद arz:ثانيه ms:Saat nl:Seconde ja:秒 no:Sekund nn:Sekund oc:Segonda uz:Soniya pnb:سکنٹ nds:Sekunn pl:Sekunda pt:Segundo ro:Secundă qu:Sikundu rue:Секунда ru:Секунда sah:Сөкүүндэ sco:Seicont sq:Sekonda scn:Secunnu simple:Second sk:Sekunda sl:Sekunda szl:Sekůnda sr:Секунд sh:Sekund su:Detik fi:Sekunti sv:Sekund ta:நொடி (கால அளவு) roa-tara:Seconne th:วินาที tr:Saniye uk:Секунда ur:ثانیہ vi:Giây wa:Sigonde war:Segundo wo:Saa yi:סעקונדע zh-yue:秒 (時間) bat-smg:Sekondė zh:秒