|
ON THIS PAGE: Food safety etc Regulations and standards |
home > the wto > what is the wto? > understanding the wto > standards and safety |
More introductory information |
Problem: How do you ensure that your country’s consumers are being supplied with food that is safe to eat — “safe” by the standards you consider appropriate? And at the same time, how can you ensure that strict health and safety regulations are not being used as an excuse for protecting domestic producers? A separate agreement on food safety and animal and plant health standards (the Sanitary and Phytosanitary Measures Agreement or SPS) sets out the basic rules. It allows countries to set their own standards. But it also says regulations must be based on science. They should be applied only to the extent necessary to protect human, animal or plant life or health. And they should not arbitrarily or unjustifiably discriminate between countries where identical or similar conditions prevail. Member countries are encouraged to use international standards, guidelines and recommendations where they exist. When they do, they are unlikely to be challenged legally in a WTO dispute. However, members may use measures which result in higher standards if there is scientific justification. They can also set higher standards based on appropriate assessment of risks so long as the approach is consistent, not arbitrary. And they can to some extent apply the “precautionary principle”, a kind of “safety first” approach to deal with scientific uncertainty. Article 5.7 of the SPS Agreement allows temporary “precautionary” measures. The agreement still allows countries to use different standards and different methods of inspecting products. So how can an exporting country be sure the practices it applies to its products are acceptable in an importing country? If an exporting country can demonstrate that the measures it applies to its exports achieve the same level of health protection as in the importing country, then the importing country is expected to accept the exporting country’s standards and methods. The agreement includes provisions on control, inspection and approval procedures. Governments must provide advance notice of new or changed sanitary and phytosanitary regulations, and establish a national enquiry point to provide information. The agreement complements that on technical barriers to trade. > more on sanitary and phytosanitary measures
Technical regulations and standards back to top Technical regulations and standards are important, but they vary from country to country. Having too many different standards makes life difficult for producers and exporters. If the standards are set arbitrarily, they could be used as an excuse for protectionism. Standards can become obstacles to trade. But they are also necessary for a range of reasons, from environmental protection, safety, national security to consumer information. And they can help trade. Therefore the same basic question arises again: how to ensure that standards are genuinely useful, and not arbitrary or an excuse for protectionism. The Technical Barriers to Trade Agreement (TBT) tries to ensure that regulations, standards, testing and certification procedures do not create unnecessary obstacles. However, the agreement also recognizes countries’ rights to adopt the standards they consider appropriate — for example, for human, animal or plant life or health, for the protection of the environment or to meet other consumer interests. Moreover, members are not prevented from taking measures necessary to ensure their standards are met. But that is counterbalanced with disciplines. A myriad of regulations can be a nightmare for manufacturers and exporters. Life can be simpler if governments apply international standards, and the agreement encourages them to do so In any case, whatever regulations they use should not discriminate. The agreement also sets out a code of good practice for both governments and non-governmental or industry bodies to prepare, adopt and apply voluntary standards. Over 200 standards-setting bodies apply the code. The agreement says the procedures used to decide whether a product conforms with revelant standards have to be fair and equitable. It discourages any methods that would give domestically produced goods an unfair advantage. The agreement also encourages countries to recognize each other’s procedures for assessing whether a product conforms. Without recognition, products might have to be tested twice, first by the exporting country and then by the importing country. Manufacturers and exporters need to know what the latest standards are in their prospective markets. To help ensure that this information is made available conveniently, all WTO member governments are required to establish national enquiry points and to keep each other informed through the WTO — around 900 new or changed regulations are notified each year. The Technical Barriers to Trade Committee is the major clearing house for members to share the information and the major forum to discuss concerns about the regulations and their implementation. |
|
|
|
contact us : World Trade Organization, rue de Lausanne 154, CH-1211 Geneva 21, Switzerland